Installation and Maintenance Instructions

Tamaño: px

Comenzar la demostración a partir de la página:

Download "Installation and Maintenance Instructions"

Ignacio Carrasco Alvarado
hace 6 años
Vistas:

1 Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one () year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/ or replace it. To obtain warranty service, products must be returned to... T&S Brass and Bronze Works, Inc. Attn: Warranty Repair Department Saddleback Cove Travelers Rest, SC 9690 Shipping, freight, insurance, and other transportation charges of the product to T&S and the return of repaired or replaced product to the purchaser are the responsibility of the purchaser. Repair and/or replacement shall be made within a reasonable time after receipt by T&S of the returned product. This warranty does not cover Items which have received secondary finishing or have been altered or modified after purchase, or for defects caused by physical abuse to or misuse of the product, or shipment of the products. Any express warranty not provided herein, and any remedy for Breach of Contract which might arise, is hereby excluded and disclaimed. Any implied warranties of merchantability or fitness for a particular purpose are limited to one year in duration. Under no circumstances shall T&S be liable for loss of use or any special consequential costs, expenses or damages. Some states do not allow limitations on how long and implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. Specific rights under this warranty and other rights vary from state to state. P/N: Rev. Date: Drawn: CW Checked: Approved: MW MAB WORKBOARD FAUCET B-7 and B-7 (with diverter valve) Deutsch: Installations- und Wartungsanleitungen Español: la Instalación y las Instrucciones de Mantenimiento Français: les Instructions d Installation et d Entretien

2 Exploded View * Some items are listed for instructional purposes and may not be sold as separate parts.

3 Part Number Guide Base Faucet Assemblies Base Faucet * Washer, Shank Locknut Washer Seat Valve, Diverter Piston Escutcheon Body (B-7) Escutcheon Body (B-7) Locknut, Cover Pl Asm, Spindle - LH Asm, Spindle - RH Spindle - LH Spindle - RH Handle - Cold Handle - Hot Index, Button - Blue Index, Button - Red Screw, Lever Handle Adapter, Diverter "O"-Ring, Center Body Screw, Diverter Cover Cover, Diverter * 4 * Optional Supply Connector Kit B-00-K * Order Separately Nozzle Assemblies 8 Nozzle Tip Washer Screen Swing Nozzle - 8" Hose Guide Hose Spray

4 Nozzle Installation: General Instructions Note: Nozzle should be installed first. See diagram below:. Place no.7 over no.4. Insert no.6 into each side of no.7.. Apply teflon tape or pipe joint compound to threaded end of no.. Screw no. into no.7, rotate no.4 so that no is facing front, tighten no Faucet Installation: 6. Shut off water supply and drain lines. Drill (4) four holes ( holes for B-7), into countertop where you are installing no. water supply sink 5. Reinstall no. and no. back onto no. shank under bottom of sink. Connect water supply to no.. 6. Tighten no. with a wrench. Spray Hose/Diverter Installation 7. Disassemble no., place shank of no. thru hole for no.. Tighten locknut of no.. water supply sink 8 (for B-7) 4 (for B-7) 4 Min. -/4 Ø Ø 4 (for B-7) (for B-7) for no. 8. Apply teflon tape to threaded end of no.. Insert no. through no. and attach to no.. 9. Turn on water supply and check for leaks. 4. Place no. into the () three predrilled mounting holes. 4

5 Instrucciones Generales Instalación De La Boquilla: Nota: La boquilla debe de ser instalada primero. Mire el dibujo de abajo:. Coloque la parte No.7 sobre la parte No.4. Coloque las partes No.6 dentro de ambos lados de la parte No.7.. Aplique cinta para rosca de tubería o compuesto de coyuntura al extremo con roscas de la parte No.. Atornille la parte No. entre la parte No.7, gire la parte No.4 debido a que la parte No. esté oscilada hacia el frente, aprete la parte No Instalación De La Canilla:. Cierre la fuente principal de agua y desagüe las tuberias. Perfore (4) cuatro huecos ( hueco para la unidad B-7), en el mostrador donde será instalada la parte No.. Surtido De Agua Lavatorio 5. Instale de nuevo las partes No. y No. en el tronco de la parte No. debajo del fondo del lavatorio. Conecte el surtido de agua a la parte No.. 6. Con una llave aprte la parte la parte No.. Instalación Del Desviador para La Manguera Roceadora 7. Desarme la parte No., coloque el tronco de la parte No. a través del hueco para la parte No.. Aprete la contra tuerca de la parte No.. 0cm (por B-7) 0cm (por B-7) 0cm Min. Lavatorio cm Ø.5cm Ø 0cm (por B-7) 5cm (por B-7) por No. 4. Coloque la parte No. entre los () tres huecos hechos anteriormente. 8. Aplique cinta para rosca de tubería al extremo con rosca de la parte No.. Insarte la parte No. a través de la parte No. y júntelo a la parte No.. 9. Abra la fuente de agua e inspeccione por filtraciones. 5

6 Instructions Générales L Installation De L Ajutage: Noter: Les ajutages devoir être installer au début. Voir le diagramme ci-dessous:. Mette Nº.7 sur Nº.4. Insérer Nº.6 dans chaque côté de Nº.7.. Appliquer le ruban en Téflon ou le composé pour les tuyaux à l extrémité avec les filets de Nº.. Visser Nº. dans Nº.7, tourner Nº.4 jusqu à Nº. être en face, resserrer Nº le tuyau qui fournir l eau 5. Réinstaller Nº. et Nº. sur la jambe au-dessous l évier. Brancher le tuyau qui fournir l eau à Nº.. 6. Resserrer Nº. avec une clef. l évier Le Tuyau De Jet/ L Installation D Aiguillage: 7. Désassembler Nº., mettre la jambe de Nº. à travers le trou de Nº.. Resserrer l écrou de Nº.. L Installation Du Robinet:. Fermer la réserve de l eau et égoutter la tuyauterie. Percer (4) quatre trous ( trous pour B-7) dans le comptoir où vous aller installer Nº.. 0cm (pour B-7) 0cm (pour B-7) 0cm Min. l évier cm Ø.5cm Ø 0cm (pour B-7) 5cm (pour B-7) pour Nº. 4. Mettre Nº. dans les trois trous déjà préparés. 8. Appliquer le ruban en Téflon à l extrémité avec les filets de Nº.. Inserer Nº. à travers Nº. et attacher à Nº.. 9. Recommencer l eau et vérifier s il y a des fuites. 6

7 Allgemeine Anleitungen Schwenkhahninstallation: Anmerkung: Der Schwenkhahn ist als ertes zu installieren. Siehe Zeichnung unten:. Nr.7 auf Nr.4 aufsetzen. Nr.6 in beide Seiten von Nr.7 einfügen.. Teflonband oder Rohrdichtmasse auf das Gewinde von Nr. auftragen. Nr. in Nr.7 einschrauben, Nr.4 so drehen, daß Nr. nach vorn ausgerichtet ist, Nr.6 anziehen. 7 4 Armatureninstallation:. Wasserzufuhr abstellen und Leitungen entleeren. Vier (4) Löcher ( Löcher für B-7) in die Abdeckpatte bohren, wo Nr. installiert wird. 0cm (für B-7) 0cm (für B-7) 6 0cm Min. Wasserzufuhr Spültisch 5. Nr. und auf der Unterseite des Spültisches wieder auf den Schaft von aufsetzen. Nr. mit der Wasserleitung verbinden. 6. Nr. mit einem Schraubenschlüssel anziehen. Brausenschlauch/Installation des Umstellers 7. Nr. auseinandernehmen, Schaft von Nr. durch das Loch für Nr. stecken. Gegenmutter von Nr. anziehen. Spultisch cm Durchmesser,5cm Durchmesser 0cm (für B-7) 5cm (für B-7) 4. Nr. in die drei vorgebohrten Löcher einsetzen. für Nr. 8. Das Gewinde von Nr. mit Teflonband umwickeln. Nr. durch Nr. hindurchstecken, Nr. anziehen. 9. Wasserzufuhr andrehen und auf Lecks prüfen. 7

8 RELATED T&S BRASS PRODUCT LINE B-5 Back-Mounted Workboard Faucet T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products Saddleback Cove, P.O. Box 088, T & S Brass-Europe Travelers Rest, SC 9690 De Veenhoeve Phone: (864) Oude Nieuwveenseweg 84 Fax: (864) CW Nieuwveen tsbrass@tsbrass.com The Netherlands

Documentos relacionados

Installation and Maintenance Instructions

Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship